How to install bath tub installation

Many people end up with a full day of work and are willing to soak in the Bathtub to ease the fatigue of the day. If you want to be so carefree, you must have a bathtub at home. Many people don’t even know how to install the tub even if they buy it. The first time you installed a friend, it was a headache. Then, how do you install the bathtub ? Take us today to see how the bathtub is installed and the installation instructions for the bathtub for Freestanding Bathtub.

How to install bathtub

Free-standing bathtub

This kind of installation method is very simple, that is to put the bathtub on the water, sewer laying and positioning, and then put the fish tank on the two wooden bar, the upper and lower water pipes connected to the bathtub, so that the installation of the bathtub can be almost At this time, turn on the water again and start the water injection into the bathtub to see if there is a water leak in the upper and lower water pipes. If not, you can remove the wooden bar, so that the free-standing bathtub is installed. finished.

2. Built-in bathtub

It is a type of bathtub that is directly embedded in the wall. Such a bath installation will be more difficult, but the basic steps are similar to the installation of a free-standing bathtub. We must first put the upper and lower water pipes to be laid, and then repair the waterproof layer at the places where the pipes are grooved. After doing a waterproof inspection of the bathroom, we must use the foam bricks to lay the embedded bathtub on the ground after laying the floor. The height does not exceed sixty centimeters.

Installation of the bathtub

1. When installing, confirm the horizontal position of the installation position of the bathtub, whether the right, left, or right position is appropriate. Then, how is the speed of the bathtub's water going? Will the phenomenon of infiltration appear? Shake the bathtub and see if the bathtub is stable. The surface of the bathtub will not produce any traces of bumping due to installation. If the glaze is damaged, the service life of the bathtub will be greatly reduced.

2. There is a jacuzzi on the market. It requires continuous circuit for installation during installation. In order to ensure the safety of occupants, it is necessary to check the connection of the circuit. The installation of the whirlpool bath must be equipped with a grounding wire and leakage protection. Switch should be tried before use. Before the continuous water pipe, it is necessary to make a power test of the motor and listen to whether the sound meets the requirements.

3. If the bathtub is equipped with a bracket, check whether the position of the bathtub is flat. This can prevent the stability of the bathtub from falling due to the unevenness of the floor. You can put the bathtub in a reserved position and use a level gauge. And adjust the support foot nut until the bathtub level is flat.

The relevant information on how to install the bathtub was introduced to everyone here. I hope that the above arrangement will help you a lot. Interested friends can access some relevant information online, and you can also consult our website online. We will do as soon as possible. You answer questions.

Bathtub Family Bath Tub Installation for the freestanding bathtub ,Drop In Bathtub and baby bathtub.